Whether you use natural gas or electricity as your primary energy source, making small changes can make a big difference when it comes to saving energy.

Here's a typical breakdown for your energy usage.*

*Information obtained from ENERGY STAR^®.

Here Are Some Tips to Help You Save Energy

• Turn off all lights, televisions, radios and appliances when they're not in use.
  
  
• Use low-wattage light bulbs, and replace your incandescent bulbs with fluorescent ones whenever possible.
  
  
• Dust or vacuum ducts, registers, radiators and refrigerator coils regularly, and bleed air from hot water radiators periodically.
  
  
• Keep heating and air conditioning system filters clean. When the filters are dirty or clogged, these systems must work harder, requiring more energy.
  
  
• If you have a hot water or steam system, bleed the radiator to remove air that can reduce the radiator's efficiency. This can be done with a simple radiator key (available at your local hardware store).
  
  
• Inspect heating and cooling equipment annually, or as recommended by the manufacturer. If you have a forced air furnace, check your filters and replace them as needed. Generally, they should be changed about once every month or two, especially during periods of high usage. Have a professional check and clean your equipment once a year.
  
  
• Check your ductwork for dirt streaks, especially near seams. These indicate air leaks, and they should be sealed with duct mastic. Insulate any ducts or pipes that travel through unheated spaces. An insulation R-Value of 6 is the recommended minimum.
  
  
• Reduce your water-heating bill by 10 percent by lowering the water heater temperature from 140º Fahrenheit to 120º Fahrenheit. Keep the temperature at 140º Fahrenheit if you use a dishwasher without a temperature booster.
  
  
• Once a year, drain a bucketful of water out of the bottom of the water heater tank. This gets rid of sediment, which can waste energy by "blocking" the water in the tank from the heating element.
  
  
• Insulate your hot water supply pipes to reduce heat loss. Hardware stores sell pipe insulation kits.
  
  
• Don't heat or cool unused space in your home. Close registers in extra rooms or cover them (be sure to use nonflammable material) if they are not adjustable. However, do not close more than 20 percent of the registers in your home. This might interfere with the operation of the central heating and cooling system. Do not block return air vents.
  
  
• Clean your thermostat yearly to keep it accurate. Just remove its cover and blow away accumulated dust.
  
  
• Replace your old thermostat with one of the newer clock models that can be set to automatically lower the temperature at bedtime and raise it in the morning. Some can be programmed to raise the setting several times a day.
  
  
• Install insulating gaskets in electrical outlets or switches on outside walls. Kits are available at hardware and home improvement stores. Generally, you can do five receptacles and seven switches for under $5.
  
  
• Make sure your thermostat is located on an interior wall. Keep sources of heat, like lamps, stereos and televisions, away from the thermostat. They will interfere with its ability to measure the room temperature accurately.
  
  
• Computers screen savers do not save electricity in computer monitors; they are meant to prevent phosphor "burn-in" on the screen. If you leave your computer and other office equipment on all the time, you are likely spending well over $100 per year on electricity!
  
  
• If your computer has a "sleep" mode, make sure that this feature is enabled. With sleep mode active, the computer will automatically convert to a low-energy mode when not in use, cutting energy usage to less than half.
  
  
• Turn off the computers when not being used for a long period of time. On the other hand, don't constantly turn your computer off and then turn it back on again. This can wear down the computer's components and actually use up more energy while starting up.
  
  
• Turn off printers, speakers, and scanners when not being used.
  
  
• Replace your most frequently used incandescent bulbs with compact fluorescent lights. Start with the lights you leave on for long periods, such as those which illuminate front and back doors and porches and the bulbs outside and inside the garage. Then change the bulbs in your laundry, utility and storage rooms, basement, attic, and shed.
  
  
• If you prefer incandescent bulbs, try to use "energy saver" bulbs. These bulbs use halogen gases that allow the filament to burn brighter while consuming less electricity.
  
  
• Replace outdoor lighting with motion-detector lighting. Outdoor lights that are left on all night can add unnecessary costs to your power bill. Using a bulb or fixture with a motion detector solves this problem. Installing a new fixture may require some professional assistance, but it's worth the cost.
  
  
• Use dimmers to reduce the wattage and output of light bulbs. Dimmers also significantly increase the life of incandescent bulbs. Keeping lights and fixtures clean can improve efficiency as much as 20 percent. Take advantage of reflected light by keeping portable fixtures as close as possible to light colored walls or other surfaces.
  
  
• Repair and weatherize your current storm windows, if necessary.
  
  
• Install tight-fitting, insulating window shades on windows that feel drafty after weatherizing.
  
  
• In the winter, close your curtains and shades at night and open them during the day to let the sun warm the room.
  
  
• Low-cost options for improving windows are caulking, weather stripping, retrofit window films and window treatments.
  
  
• Landscaping can help block and absorb the sun's energy by providing shade and evaporative cooling, which can reduce the air temperature around your home. Air temperatures can be 3 to 6 degrees cooler in tree-shaded neighborhoods than in those with few or small trees.
  
  
• Evergreen trees planted on the northwest corner of your property can block winter winds and can save you up to 10 percent on your heating bill.
  
  
• Windbreaks planted on three sides of the house can save up to 15 percent on your heating bill.
  
  
• Plant shade trees (deciduous trees) on the south and west sides of your house. In the winter, deciduous trees without their leaves let in the sun to warm your home. In summer, deciduous trees can block 70 percent to 80 percent of the sun's radiation.
  
  
• Shade your air conditioner to increase its efficiency by 10 percent during peak periods.
  
  
• Shrubs planted on all sides of the house help reduce wall and soil temperatures.
  
  
• Plant vines on a trellis a few feet from the wall to shade your walls and windows.
  
  
• Replace old appliances with Energy Star appliances. Having an energy efficient refrigerator, dishwasher, and clothes washer can save you 30 percent on your energy bill compared to lower efficiency appliances.
  
  
• If you have a pool or spa, set the heater thermostat to 78° or lower.
  
  
• Use a timer on your pool or spa to operate the filter pump.
  
  
• Check with your pool supply advisor for recommendations on how long to run your pool pump daily. Don't run it any longer than necessary.
  
  
• Use a cover or blanket on pools and spas when they are not in use.
  
  
• Run your pool pump during off-peak hours. Summer peak hours are 10 a.m.-5 p.m.